Datalogic DX6400 Installationshandbuch PDF herunterladen (Seite 12)

GUIDE TO INSTALLATION

POINT-TO-POINT INSTALLATION

The following can be used as a checklist to verify all the steps necessary to complete

installation of the DX6400 scanner.

1) Read all information in the section “Safety Precautions” at the beginning of this manual.

2) Correctly mount the scanner according to the information in par. 2.2 and position the

reader at the correct reading distance according to the reading diagrams in par. 4.5.

3) Make electrical connections to your DX6400 scanner by:

a) Connecting the DX6400 scanner to the C-BOX 100 by means of one of the cables

provided as accessory (see par. 1.5).

b) Providing correct and complete system cabling through the C-BOX 100 according to

the signals (trigger, inputs, outputs) necessary for the layout of your application.

• Layout: Point-to-Point, RS232 Master/Slave, Lonworks, Fieldbus. See sub-

paragraphs under 2.5 for reference.

• Cabling: Power, Main Serial Interface – RS232, RS485 Half Duplex, RS485 Full

Duplex, 20 mA Current Loop, Auxiliary Interface, Inputs, Outputs, etc -. For further

details, see all sub-paragraphs under par. 2.3.

4) Configure the DX6400 scanner by installing and running the Genius™ configuration

program from the CD-ROM provided. The main steps are:

• Select the codes to be read

• Set-up the communication parameters

• When PackTrack™ is required, set the PS Offset and Position parameters

• Define data formatting parameters

NOTE

Fine tuning of the scanner position for barcode reading can be

accomplished by performing a test through the SPY configuration tool

in Genius™.

5) Exit the configuration program and run your application.

The installation is now complete.

xii

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 93 94

Keine Kommentare

Datalogic DX6400 Installationshandbuch Seite 12