Datalogic SC6000-1200 Bedienerhandbuch PDF herunterladen (Seite 37)

INSTALLATION

2.6.2 Redundancy Mode

When working in a redundant system, the SC6000 displays different windows according to its

redundancy role (refer to the SC6000 Help On-Line for further details).

SC6000 Active Controller Window

The SC6000 working as active controller displays the diagnostic mask window, as if it is

working in a single master network.

SC6000 Standby Controller Window

This window is displayed on the SC6000 working as standby controller. It illustrates the

topology redundancy role of the controller:

 “Protecting/Standby” or “Working/Standby“

2.6.3 Menu Mode

For security purposes, the menu mode is entered by pressing the Enter and Menu keys at

the same time. To navigate in the menus the keypad keys are used as follows:

Press Enter to select an item or enter a branch level.

Press Clear to exit an item without saving or return to the previous branch level.

Press the Up or Down arrow keys to scroll through a branch list.

It is possible to access the System menu, Setup parameters menu or the PackTrack menu:

Menu Branch Branch Note

System

Info Shows the System Info Window

Reset Reset the system (asks for confirmation)

Restore DARP Restore procedure

Complete Restore system configuration

All Slaves Restore only all slaves configuration

Controller Restore only SC6000 configuration

Slave … Restore single specific slave configuration

Backup DARP Backup procedure

Complete Backup system configuration

All Slaves Backup only all slaves configuration

Controller Backup only SC6000 configuration

Slave … Backup single specific slave configuration

Last Codes

Shows the last 10 codes read:

Up or Down to scroll through the list; one code

per display screen

The Backup and Restore procedures can also be performed in Genius™, (see chapter 4 for

details).

This option is available only when the Show Last Code Window parameter is enabled from Genius™.

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 76 77

Keine Kommentare

Datalogic SC6000-1200 Bedienerhandbuch Seite 37