Datalogic QuickScan QS6500BT Spezifikationen PDF herunterladen (Seite 29)

Label Gone Timeout

Product Reference Guide

Label Gone Timeout

This feature sets the time after the last label segment is seen before the reader prepares for

a new label. The timeout can be set within a range of 10 milliseconds to 2,550 millisec-

onds (2.55 seconds) in 10ms increments. Label Gone Timeout does not apply to scan

modes that require a trigger pull for each label that is read

Follow these instructions to set this feature:

1. Determine the desired setting in milliseconds.

2. Divide the desired setting by 10 (setting is in 10ms increments). Pad the result with lead-

ing zeroes to yield three digits. For example: 0 = 000, 5 = 005, 20 = 020, etc.

3. Scan the ENTER/EXIT PROGRAMMING MODE bar code to enter Programming

de.

4. Scan the bar code: SELECT LABEL GONE TIMEOUT SETTING.

5. Scan the appropriate three alpha-numeric

characters from the keypad in Appendix E,

Keypad representing the duration which was determined in the steps above. You will hear

a two-beep indication after the last character.

NOTE

If you make a mistake before the last character, scan the CANCEL bar

code to abort and not save the entry string. You can then start again at

the beginning.

6. Scan the ENTER/EXIT PROGRAMMING MODE bar code to exit Programming

Mode.

This completes the procedure. See Table 2 for some examples of how to set this feature.

Table 2. Timeout Setting Examples

STEP ACTION EXAMPLES

1 Desired Setting 50ms 150ms

1800ms (1.8

sec.)

2550ms (2.55 sec.)

Divide by 10 (and pad with

lead

ing zeroes)

005 015 180 255

3 Scan ENTER/EXIT PROGRAMMING MODE

4 Scan SELECT LABEL GONE

TIMEOUT SETTING

Scan Three Characters From

Appendix E, Keypad

‘0’, ‘0’ and ‘5’ ‘0’, ‘1’ and ‘5’ ‘1’, ‘8’ and ‘0’ ‘‘2’, ‘5’ and ‘5’

6 Scan ENTER/EXIT PROGRAMMING MODE

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 387 388

Keine Kommentare

Datalogic QuickScan QS6500BT Spezifikationen Seite 29