Datalogic A30 Bedienerhandbuch PDF herunterladen (Seite 5)

GENERAL VIEW

A30™ Camera

Power Indicator LED

Power, Serial Interface, and I/O Connector

MAC Address label

Ethernet Connector

Ethernet Network Presence LED

Indicator Lights (see page 7)

Reset and Camera Button Event (see page 7)

Configuration

ASSEMBLE THE CAMERA

The first step to perform is to assemble any accessories that make up the A30™ camera. A lens

must be used. A strobe or other external illuminator may be required.

CAUTION

The camera must be disconnected from the power supply during this

procedure.

1. In a dust-free environment, remove the Camera Lens Cover by unscrewing it.

CAUTION

Do not touch the sensor aperture, lens glass or lens cover glass. These

areas must be kept clean. Avoid any abrasive substances that might

damage these surfaces during cleaning.

2. Remove the sensor protection label (dust cap) by pulling it off of the base.

3. Mount a lens by slowly screwing it onto the base until it arrives at the mechanical stop.

1 2 3 4 5 6 7 8 9 10 ... 21 22

Keine Kommentare

Datalogic A30 Bedienerhandbuch Seite 5