Datalogic DS2100N Bedienungsanleitung PDF herunterladen (Seite 12)

Setup Procedure Using Programming Barcodes

NOTE

If it ever becomes necessary to return to a Point-to-Point (Stand Alone)

configuration you can execute the Reset Reader To Factory Default

procedure from the X-PRESS™ push button.

1.3 RESET READER TO FACTORY DEFAULT (OPTIONAL)

If it ever becomes necessary to reset the reader to the factory default values, you can

perform this procedure by holding the X-PRESS™ push button pressed while powering up

the reader. You must keep the X-PRESS™ push button pressed until the power up

sequence is completed (several seconds) and all LEDs blink simultaneously 3 times.

All LEDs remain on for about 1 second, then off for one second, the Configuration and

Environmental parameters are reset, and the status LED remains on. If connected through a

CBX500 with display module, the message "Default Set" is shown on the display.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 33 34

Keine Kommentare

Datalogic DS2100N Bedienungsanleitung Seite 12