Datalogic STAR Modem Spezifikationen Seite 46
- Seite / 197
- Inhaltsverzeichnis
- LESEZEICHEN
Bewertet. / 5. Basierend auf Kundenbewertungen
USB PARAMETERS
USB-COM
Handshaking, Ack/Nack protocol, FIFO,
Inter-character delay, Rx timeout, Serial
trigger lock
USB-KBD
Keyboard nationality, FIFO, Inter-character
delay, Inter-code delay, Control character
emulation, USB keyboard speed
USB-IBM
No parameter selection required.
1. Read the Enter Configuration code ONCE, available at the top of each page.
2. Read configuration codes from the desired groups.
= Read the code and follow the procedure given
= Default value
3. Read the Exit and Save Configuration code ONCE, available at the top of
each page.
36
- GRYPHON™ Dx30/Mx30 1
- CONTENTS 5
- GENERAL VIEW 10
- 1 INTRODUCTION 11
- 2 INSTALLATION 12
- INSTALLATION 13
- OM-GRYPHON™ Connectors 13
- 2.3 RS232 CONNECTION 14
- 2.4 USB 14
- 2.5 IBM USB POS 15
- 2.6 WEDGE CONNECTION 15
- 2.8.1 Battery Type 18
- 2.8.2 Battery Charging 18
- 2. Open the battery cover 19
- 3. Replace the 19
- LAYOUTS 20
- 3.2.1 Host Master Layout 22
- 4 CONFIGURATION 23
- 4.2 SETUP PROCEDURES 24
- Ì$+$*oÎ 25
- ÌRA0RFHÎ 25
- Ì$+RN0$-IÎ 26
- Ì$+RX0$-qÎ 26
- Ì$+RN1$-NÎ 27
- END of procedure 28
- Ì$+CP0$-$Î 31
- Ì$+CM2EC0$->Î 31
- Ì$+CM1$-ÈÎ 31
- Ì$+CM0$-ÃÎ 31
- Ì$+CP6$-BÎ 31
- Ì$+CP500$-aÎ 32
- Ì$+CP503$-vÎ 32
- Ì$+CP505$-ÈÎ 32
- Ì$+CP506$-$Î 32
- Ì$+CP504$-}Î 32
- Ì$+CP502$-oÎ 33
- Ì$+CP501$-hÎ 33
- Ì$+FK1$-ÉÎ 33
- Ì$+FK0$-ÄÎ 33
- Ì$+CP512$-uÎ 35
- Ì$+CP513$- 35
- First Start-Up 36
- RS232 PARAMETERS 39
- BAUD RATE 40
- DATA BITS 41
- STOP BITS 42
- HANDSHAKING 42
- ACK/NACK PROTOCOL 43
- INTER-CHARACTER DELAY 44
- RX TIMEOUT 44
- SERIAL TRIGGER LOCK 45
- USB PARAMETERS 46
- USB-COM 47
- USB-KBD 50
- KEYBOARD NATIONALITY 50
- INTER-CODE DELAY 52
- CONTROL CHARACTER EMULATION 52
- USB KEYBOARD SPEED 53
- WEDGE PARAMETERS 54
- CAPS LOCK 56
- NUM LOCK 57
- KEYBOARD SETTING 59
- PEN EMULATION 62
- OPERATING MODE 63
- MINIMUM OUTPUT PULSE 64
- OVERFLOW 66
- OUTPUT LEVEL 66
- IDLE LEVEL 67
- INTER-BLOCK DELAY 67
- DATA FORMAT 68
- CODE IDENTIFIER 71
- CUSTOM CODE IDENTIFIER 72
- TERMINATOR 74
- SPECIAL KEYS 75
- FIELD ADJUSTMENT 76
- FIELD ADJUSTMENT CHARACTER 77
- CODE LENGTH TX 77
- CHARACTER REPLACEMENT 78
- POWER SAVE 81
- SCAN RATE 82
- SLEEP STATE/USB SUSPEND 82
- ENTER SLEEP TIMEOUT 83
- STANDBY 83
- READING PARAMETERS 84
- HAND-HELD OPERATION 85
- STAND OPERATION 85
- HARDWARE TRIGGER MODE 86
- TRIGGER-OFF TIMEOUT 86
- FLASH MODE 87
- READS PER CYCLE 87
- SAFETY TIME 88
- BEEPER INTENSITY 88
- BEEPER TONE 89
- BEEPER TYPE 89
- BEEPER LENGTH 89
- GOOD READ SPOT DURATION 90
- DECODING PARAMETERS 92
- INK SPREAD 93
- OVERFLOW CONTROL 93
- INTERDIGIT CONTROL 94
- DECODING SAFETY 94
- PUZZLE SOLVER™ 95
- EAN/UPC FAMILY 98
- CODE SELECTION 100
- 2/5 FAMILY 105
- CODE 39 FAMILY 106
- CODE 128 FAMILY 108
- CODE 93 109
- CODABAR FAMILY 110
- PLESSEY 113
- TELEPEN 114
- DELTA IBM 115
- CODE 11 116
- CODE 16K 117
- CODE 49 117
- RSS CODES 119
- ADVANCED FORMATTING 120
- CONCATENATION 121
- RADIO PARAMETERS 139
- RADIO PROTOCOL TIMEOUT 140
- POWER-OFF TIMEOUT 140
- BATTERY TYPE 141
- SINGLE STORE 142
- 5 REFERENCES 143
- 5.1.2 ACK/NACK Protocol 144
- 5.1.3 FIFO 145
- 5.1.4 RX Timeout 146
- 5.2 PEN PARAMETERS 146
- 5.2.1 Minimum Output Pulse 146
- 5.2.3 Overflow 147
- 5.2.5 Inter-Block Delay 148
- 5.3 DATA FORMAT 148
- Enter Configuration 150
- REFERENCES 153
- ÌFQ9C2>Î 155
- 5.3.3 Address Stamping 157
- 5.3.4 Address Delimiter 157
- 5.4 POWER SAVE 158
- 5.4.2 Enter Sleep Timeout 158
- 5.4.3 Standby 158
- 5.5 READING PARAMETERS 159
- 5.5.1 Hardware Trigger Mode 159
- 5.5.2 Trigger-Off Timeout 159
- 5.5.3 Reads per Cycle 159
- 5.7.2 Power-Off Timeout 161
- 5.7.4 Single Store 162
- Ì$+ZZ0$-*Î 164
- Ì$+ZZ2$-4Î 165
- Ì$+ZZ3$-9Î 166
- Ì$+RN4$-]Î 167
- Ì$+RN6$-gÎ 167
- 6 TECHNICAL FEATURES 169
- 6.2 GRYPHON™ MX30 170
- 6.5 STATUS INDICATORS 172
- 6.6 READING DIAGRAMS 174
- TECHNICAL FEATURES 175
- AC410132BH0 177
- (100 ms) 179
- (not for USB-KBD-ALT-MODE) 180
- B CODE IDENTIFIER TABLE 190
- CODE IDENTIFIER TABLE 193
- C HEX AND NUMERIC TABLE 194
- HEX AND NUMERIC TABLE 195
- HEX / NUMERIC TABLE 196
Verwandte Produkte und Handbücher für Vernetzung Datalogic STAR Modem
(82 Seiten)
Vernetzung Datalogic Star Bedienungsanleitung
(72 Seiten)
(72 Seiten)
Vernetzung Datalogic Matrix 400 Bedienerhandbuch
(86 Seiten)
(86 Seiten)
Vernetzung Datalogic M-Series Spezifikationen
(203 Seiten)
(203 Seiten)
Vernetzung Datalogic M-Series Bedienerhandbuch
(134 Seiten)
(134 Seiten)
Vernetzung Datalogic Star Installationshandbuch
(36 Seiten)
(36 Seiten)
Vernetzung Datalogic Matrix 400 Bedienerhandbuch
(24 Seiten)
(24 Seiten)
Vernetzung Datalogic Star Installationshandbuch
(128 Seiten)
(128 Seiten)
© 2020, manymanuals.de. Alle Rechte vorbehalten. | 3.706 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Kommentare zu diesen Handbüchern